Showing 41 to 60 out of 147
Sling dates from the 1950’s or 60’s and is made of brown leather that is in excellent condition. One end has a loop of brown leather held in place by a stud while the opposite end has a “D”… (2020-122). Learn More »
$50.00
Originally $75.00
This is a very strong example of the regulation cap box for the percussion cap primers used on the majority of Civil War weapons. The box is complete, all original, and in excellent condition. The… (1304-103). Learn More »
This is a Civil War U.S. cavalry saber belt in buff leather in top notch condition, complete with both saber slings, the buff shoulder support belt as well, matching plate and keeper, and contractor… (490-7193). Learn More »
This is a fine example of the Model 1887 Carbine Boot, retaining its full form with all of the straps that remain unbroken. The rear stitched seam is intact except for about 2” at the lower end.… (1286-948). Learn More »
Designed to enable the cavalryman to carry the saber suspended from a single ring on the belt and be able to detach it and quickly get it out of the way to fight on foot, or attach it to a ring on the… (362-1272). Learn More »
This is a scarce piece of Civil War artillery related leather. This is a pendulum hausse sight case. Pendulum Hausse sights were weighted brass pieces that were mounted on the breech of a cannon and… (2025-2038). Learn More »
This is a scarce piece of Civil War artillery related leather. This is a pendulum hausse sight case. Pendulum Hausse sights were weighted brass pieces that were mounted on the breech of a cannon and… (2025-2022). Learn More »
Brown buff leather belt in good condition. Leather is a little dry causing the inside seam in one small section to split but the rest is solid. Belt plate and keeper have matching benchmark numbers of… (344-915). Learn More »
$1,250.00
Originally $1,575.00
The hefty .44 Colt Dragoon revolver was intended to be carried in saddle holsters. It was only with the adoption of the lighter M1851 .36 Colt Navy in 1855 that the army gave serious consideration to… (490-7481). Learn More »
Very nice militia box. The exterior surfaces of the box are very good. The outer flap is as smooth and clean with slight crazing. The latch tab has no tears and is attached to the underside by… (1304-89). Learn More »
The leather on this cap box is in excellent condition. Fleece and pick present inside along with a few caps. Along the edge of the inner flap is a partial inspector's stamp, and another on the latch… (1304-88). Learn More »
Bridle leather sword belt in good condition. The exterior leather surfaces show moderate surface crazing with scattered patches of flaking and loss. The leather belt is strong and supple with no weak… (490-7401). Learn More »
Civil War era non-commissioned officer’s belt buckle on original buff leather waist belt. Cast brass eagle buckle which has a three-piece applied German silver wreath and has the narrow 0.5” wide… (490-7402). Learn More »
Standard issue 1839 pattern enlistedman’s white buff leather belt with a typical, large US buckle. The belt is 1.75” wide and approximately 38” long. The leather shows light use, with the… (490-7405). Learn More »
This is a Civil War percussion cap pouch. The leather remains in fine overall condition, likely unissued. This pattern has the integral closing tab as an extension of the outer flap. The closing tab… (2025-2031). Learn More »
Black bridle leather cartridge box with lightly embossed “R.I.M.” on the flap. Closing tab stitched and riveted to the outer flap; complete and unbroken. Inside is a two-tier wood block with… (1240-29). Learn More »
This is a non-regulation, left facing, black leather holster made for revolvers. A .36 caliber “Navy” model fits into this perfectly. The holster “pocket” measures 11.5” along its front… (1179-1646D). Learn More »
This is a black leather holster made for revolvers. The leather still shows the “profile” of a revolver cylinder and barrel. A .44 caliber “Army” model fits into this perfectly. The holster… (1179-1646A). Learn More »
Offered here is the black bridle leather cover for a M1859 naval boarding ax. Not a piece commonly encountered. Main body is made of one piece, folded at front edge, and sewn along bottom edges and… (1268-1227). Learn More »
This well-made brown/black leather carbine or possibly pistol box (compatible with the single shot Palmetto 1842 model pistol for example) is of Confederate manufacture. At first glance from the front… (490-7364). Learn More »
Showing 41 to 60 out of 147
Historical Firearms Stolen From The National Civil War Museum In Harrisburg, Pa »
Theft From Gravesite Of Gen. John Reynolds »
Selection Of Unframed Prints By Don Troiani »
Fine Condition Brass Infantry Bugle Insignia »
Rare Identified 65Th Ny Sergeant’s Jacket, With Manscript Material: 1St U.s. Chasseurs »
This large cast-iron cannon was produced at the Tredegar Iron Works in Richmond, Va. In 1836, a group of Richmond businessmen and industrialists led by Francis B. Deane, Jr. set about to capitalize on the growing railroad boom in the United… (1268-1240). Learn More »